D104 Lollipop Mic Flat Head Screws and Spacers

Description

D104 Lollipop Mic Head Screws and Spacers.
These are metric sizes and not OEM SAE size but they do fit and hold the two pieces (front and back) together.
You will be sent flat head Phillips. Total of 12 pieces
Assembly is this: Use the four short screws on the front (see pictures) and screw on spacers. Align the front through the mic element and around the elements rubber spacers. Follow with the back plate and use the 4 supplied longer screws but be careful on alignment. Square up front snd back to evenly distribute the screws to the mic throat connection.
Note: these as mentioned already are metric and not SAE as OEM was. Thus metric is a tad smaller than what Astatic used as next metric size is too large to fit. If you believe these Flat Head screws could be too small, buy the the larger head screw set.
Note: the screws are hard metal and the spacer is aluminum so “DO NOT OVER TIGHTEN” as the threads on the spacer will strip.
I will not warranty strip thread as all items are QC for quality prior to shipping.
From time of sale, allow ten days till your purchase arrives at the carrier.
Thank you
Mark